Baileigh Industrial CS-350EU, Operator'S Manual

Page: 37 / 60

34
34
Blade tracking adjustment
The head pivot shaft is supported by eccentric
bushings. If blade tracks off center resulting in
crooked cuts, adjust as follows.
1. Loosen the set screw (A) from rear of head pivot
with 4mm hex wrench.
2. If blade tracks to right side (viewed from back of
the saw as shown.), rotate eccentric shaft forward.
3. If blade tracks to left side, rotate the eccentric
shaft backward.
4. Tighten set screw (A) and operate saw to verify
correctness of adjustment.
Changing the Saw Blade
1. To change the saw blade:
2. Release and pivot the mobile guard (A) by removing the
hex socket screw (B).
3. Place a block of wood into the vise.
4. Lower the machine head to rest the saw blade on the
block of wood.
5. Using a hex wrench, remove the lock bolt (C) in a
clockwise (cw) direction. (It has a left handed thread).
6. Remove the blade (D) and blade washer (E) from the
spindle.
7. Remove the blade washer from the saw blade (D).
8. Place washer (E) onto the replacement blade and follow
above procedure in reverse.
9. Check for proper blade rotation.
B
A
C
E
D
A
B