Baileigh Industrial CS-350EU, Operator'S Manual

Page: 29 / 60

26
26
OPERATION
Cutting Cycle
•
Set the miter cut angle.
•
Open the vise jaws.
•
Load and clamp the piece part.
•
Adjust the bar stop for cutting length as needed.
•
Press button (A) to turn power on to the saw. ( Green
light will be lit).
•
Set the blade speed (B), read the display (C).
•
Set the coolant switch (D) to on.
•
Grasp the feed handle (E).
•
Press the trigger switch (F) to start blade motor.
•
Pull down the feed handle (E) applying a steady and
constant pressure.
•
After cut-off, raise feed handle slowly.
•
Release the trigger switch (F) to stop the blade motor.
•
Use vise lever to open the jaws.
•
Remove or advance the piece part forward for next cut.
•
To turn off machine power press the stop button (G)
•
To stop machine in an emergency situation, press the
EMERGENCY STOP button (H).
•
Before restarting machine, emergency stop button must be
reset with a clockwise ( cw ) twist.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy material make sure they are properly supported.
NOTICE: Do not allow the saw to slam back up to the start position. Doing so will cause
damage to the pivot block and the weight of the motor will cause damage to the gear case
adaptor over time.
F
E
H
D G
A
B
C