24
24
Vise Operation
1. Use the hand wheel (A) to open and close the vise
jaw (B) for pieces that vary in width.
a. Counter clockwise (ccw) to open jaws
b. Clockwise (cw) to close jaws
2. Use the vise release lever (C) to quickly clamp and
unclamp pieces of the same width. The release
lever is a 1/2 turn lever, from straight up (loosen)
to straight down (clamped).
a. Clockwise (cw) to clamp the piece
b. Counter clockwise (ccw) to unclamp the
piece
Loading the Piece Part
1. Use the vise hand-wheel to open the jaws wider than the width of the piece.
2. Measure and mark off the length of material to be cut.
3. Place the piece on the flat surface in between the vise jaws.
4. Slide the piece through the jaws so the scribed length mark lines up with the blade or disk.
5. Push the piece up against the back vise jaw.
6. Turn the hand-wheel clockwise (cw) to clamp the piece.
If repetitive cuts are required for material of the same width:
1. Turn the vise hand-wheel clockwise (
cw
) to approach the piece part, leaving approximately
3/16” (5mm) gap between front jaw and the piece part.
2. Then use the vise lock lever to clamp and unclamp the piece.
C
B
A
Summary of Contents for CS-350EU
