10 Foot Slide Assembly
Phase 1
Phase Notes
• Drill 3 holes at one end of the plastic slide bed using a 5/16" drill bit and using the
dimensions shown below. This end will be the top of the slide.
• Take note of slide bed surface finish, the dull side will be towards the ground. Place
slide brace centered on the bottom (dull side) and 1/4" from the edge. Transfer holes
on the board through the slide bed as shown below. Use a 5/16" drill bit.
• Attach slide brace to slide using hardware shown.
SLIDE BED 10' LIGHT GREEN
DULL SIDE
TOP
BOTTOM
NUT BARREL WH 5/16x5/8
WASHER LOCK EXT 12x19
BOLT WH 5/16x1/2
M70
Tip: Pre-bending the ends will ease assembly.
1/2
3
10
17
QTY. DESCRIPTION LABEL
1 SLIDE BED 10' YELLOW KE
1 SLIDE BED SUPPORT M70
3 BOLT WH 5/16x1/2 CM
3 WASHER LOCK EXT 12x19 AD
3 NUT BARREL WH 5/16x5/8 B
