Instruction 24-9395
26
Fyrite Pro
4.8 Printing Test Data
Tip:
To avoid printing errors, it is important to select the
correct protocol per Section 3.5.8
before
saving data.
Turn ON the prnter.
Refer to the printer’s instruction manual for detailed
operation and maintenance information.
If not already done, set the prnter parameters as follows:
• Data: 8 bts
• Party: None
• Baud: 9600
• Handshakng: X-on/X-off
Algn the prnter wth the top of the analyzer as shown n Fgure 4-1.
The next step n the prntng procedure depends on the model of the ana-
lyzer, and whether the operator desres to prnt only the current test data,
or all stored test data startng wth the most recent. Perform the appropr-
ate procedure below:
Model 100 – Print Current Test Data
Wth the analyzer n ts Run Mode, begn prntng by pressng the
hOlD
button
twice
.
Model 105/110/120/125 – Print Current Test Data
1. Wth the analyzer n ts Run Mode, press the
hOlD
button
twice
to
dsplay the Prnt Screen.
2. Press
eNTeR
to start prntng.
Model 105/110/120/125 – Print All Test Data
1. Wth the analyzer n ts Run Mode, press the
hOlD
button
twice
to dsplay the Prnt Screen. Then press the
button to dsplay the
Prnt All Screen.
2. Press
eNTeR
to start prntng.
Summary of Contents for 100
Page 6: ...Fyrite Pro Instruction 24 9395 iv Notes...
Page 22: ...Instruction 24 9395 16 Fyrite Pro Notes...
Page 46: ...Instruction 24 9395 40 Fyrite Pro Notes...
Page 58: ...Instruction 24 9395 52 Fyrite Pro Figure 5 4 Case Components Plumbing Schematic...
