Instruction 24-9395
6
Fyrite Pro
3.3 Connecting the Probe hose and
Thermocouple
The analyzer’s model number determnes whch hose and thermocouple
connectons are made at the bottom of the unt. Perform the followng steps
as requred by your partcular analyzer model (see Fgures 3-2A thru D):
1. Push the probe’s sample-gas hose onto the GAS nlet fttng.
2. Push the probe’s draft hose onto the “+” pressure fttng.
3. Push the probe’s thermocouple nto the T-STACK jack
Important:
DO NOT force the thermocouple connector into
its jack. The connection tabs are different sizes, allowing the
connector to fit in only one way.
4. Push the optonal room-ar/prmary-ar thermocouple nto the
T-AIR jack.
Inspect the flue-gas hose for cracks. If a hose s defectve, replace the entre
probe assembly.
Before usng the analyzer, check that the Water Trap / Flter s dry and
not drty. If necessary, dry out the trap and replace the flter element per
Secton 5.8.
Summary of Contents for 100
Page 6: ...Fyrite Pro Instruction 24 9395 iv Notes...
Page 22: ...Instruction 24 9395 16 Fyrite Pro Notes...
Page 46: ...Instruction 24 9395 40 Fyrite Pro Notes...
Page 58: ...Instruction 24 9395 52 Fyrite Pro Figure 5 4 Case Components Plumbing Schematic...
