Baby Lock Embroidery Professional PLUS BMP9, Instruction And Reference Manual

Page: 112 / 276

OTHER BASIC PROCEDURES —————————————————————————————————————————————————————————————————
110
Resume Embroidering After Turning Off the Machine
In either of the following cases, the remaining stitches of the embroidery are stored in the machine’s
memory.
• If the machine’s power switch is pressed to turn off after stopping embroidering.
Cut the thread before the machine’s main power switch is turned off, otherwise the thread may be pulled
or may catch when the carriage returns to its initial position after the machine is turned on again.
• If the machine was accidentally turned off, for example, due to a power outage, while it was
embroidering.
The remainder of the embroidery can be sewn when the machine is turned on again; however, some of
the stitches that were already sewn may be sewn again.
Note
●
Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
1
Set the main power switch to “I” to turn on
the machine.
2
When the machine is turned on, the opening
movie is played. Touch anywhere on the
screen to display the message below.
3
Touch .
X
A message appears, asking if you wish to
continue embroidering or start a new
operation.
4
Touch .
1 Touch to continue embroidering.
2 Touch to cancel embroidering and display the
pattern type selection screen to select a new
pattern.
X
The embroidering screen displayed before
the machine was turned off appears.
2
1