Axonics Model 1601, Manual

Page: 16 / 120

16
Figure 3: Align the raised grey bar on the TS with the raised bar on the Basic Trial Cable (shown) or
the grey line on the PE (not shown). Plug the Basic Trial Cable or PE fully into the extension of the TS.
Inserting TS into the Belt
The following section describes the placing theTS into the provided belt.This procedure should be performed when an Axonics lead
has already been implanted.
1. Fit the belt around the patient’s waist. Fasten and adjust the belt width as necessary (
Figure 4
).The belt should be worn such
that it is comfortable for the patient. The pouch for the TS is located above the patient’s hip.
2. Slide the TS into the pouch on the belt. Position the TS extension looped around the TS ( Figure 5 ). The TS is fully inserted when
it passes the narrow point of the pouch.
3. Coil any excess cable and place it in the pouch.
Figure 4:
Fasten the belt on the patient’s body and adjust the width as necessary
110-0049 rev G_output.indd 16 11/20/18 7:08 AM