A
XELL
BSF-4004
BSF0038
S
ERIES
R
EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Caution: Safety to
equipment
When installing, replacing or using this product, observe all safety
precautions during handling and operation. Failure to comply with the
following general safety precautions and with specific precautions
described elsewhere in this manual violates the safety standards of the
design, manufacture, and intended use of this product.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Axell Wireless assumes no liability for the customer's failure to
comply with these precautions. This entire manual should be read and
understood before operating or maintaining the repeater.
Warning: Restricted
Access Location
Access to the Axell unit installation location is restricted to SERVICE
PERSONNEL and to USERS who have been instructed on the
restrictions and the required precautions to be taken.
Attention:
Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device
.
Static electricity can be conducted to the semiconductor chip from the
centre pin of the RF input connector, and through the AC connector
pins. When unpacking and otherwise handling the repeater, follow
ESD precautionary procedures including use of grounded wrist straps,
grounded workbench surfaces, and grounded floor mats.
Caution: Class 1 Laser
The repeaters described in this manual are equipped with class 1 lasers,
as per definition in EN 60825-1
Caution
- Un-terminated optical receptacles may emit laser radiation.
Exercise caution as follows:
•
Do not stare into beam or view with optical instruments. Optical
transmitters in the fibre optic converter can send out high energy
invisible laser radiation. There is a risk for permanent damage to
the eye.
•
Always use protective cover on all cables and connectors which
are not connected.
•
Never look directly into a fibre cable or a connector.
•
Consider that a fibre can carry transmission in both directions.
•
During handling of laser cables or connections, ensure that the
source is switched off.
•
Regard all open connectors with respect and direct them in a safe
direction and never towards a reflecting surface. Reflected laser
radiation should be regarded as equally hazardous as direct
radiation.
VIII
Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0
© Axell Wireless Ltd
