A
XELL
BSF-4004
BSF0038
S
ERIES
R
EPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
3.7 Power and Backup Battery
Caution!
Make sure the antenna cables or 50 ohm terminations are connected to the repeater’s
antenna connectors before the repeater is turned on.
Caution!
Be sure a CIRCUIT BREAKER meeting the instructions given in this section is
connected near the unit at an easily reachable and accessible location from the unit.
3.7.1 Circuit Breaker
The power connections to the unit are hard-wired. To disconnect the unit (either manually or
automatically in case of overcurrent), it is required to install a circuit breaker
on the wall
near
the
unit
, at an easily accessible distance and location from the unit.
Circuit-breaker minimum requirements
•
10AT, 250VAC
•
Needs to be SAFETY approved
•
Requires minimum contact separation of 3mm.
•
Install on the wall near the unit
3.7.2 Power Connections
The image below shows the location of the various power elements. These are described in detail in
the following sections.
Figure
3-15: Power Elements – Located Inside Repeater
115/230 VAC
power
connections
Backup battery pack
Battery (BATT)
ON/OFF switch
Power ON/Standby
switch
14
Doc. No. PN 4004 BSF0038 Series-UM Rev. 1.0
© Axell Wireless Ltd
