Jet Cleaner TANKO-MX
2 Safety
Operating/Installation Instructions 2019/08
9/102
The device was developed, engineered and built exclusively for industrial and commercial use. It must
not be used for private use.
The device is constructed so that it can be operated safely within the specified technical parameters
(see
Section 3.3 Technical Data
).
In all cases, operating company must check whether the device is suitable for its application.
Locations for containers in which the device is to be installed are usually enclosed spaces. In different
setups, the operating company must ensure the protection of the device from harmful weather and
environmental influences while maintaining the specified application limitations/conditions (see
Section 3.3 Technical Data
).
In the process, the following must always be observed:
Only operate the device when installed inside an enclosed container.
Never direct the cleaning jet or torrent from the device at persons.
Protect the device from freezing (e.g. risk of frost from possible residual water).
Use a suitable filter system in the supply line for the cleaning medium.
Operate the device only within the approved parameters (see
Section 3.3 Technical Data
). If
necessary, appropriate monitoring and limiting systems (e.g. for pressure and temperature) should
be implemented.
Only cleaning agents which are compatible with the materials of the device (see
Section 3.4
Cleaning
media).
The preferred installation position for the device is vertical with the cleaning head pointing
downwards. Other installation locations (see
Section 5.2.2 Installation
Position) are possible.
The device may generate vibrations when cleaning the container. Any vibrations going beyond this
must be avoided (see
Section 7.4.1 Maintenance
Intervals).
The device is designed for fixed pipe installation only. Installation on a hose is PROHIBITED.
Non-Intended Use
The device is NOT suitable for the following applications:
The device is NOT suitable for private use.
The device is NOT suitable for use outside of containers.
Holding the device with your hand during operation is PROHIBITED.
The device must NOT be immersed in the product of the production process (NOT even partially).
This could cause the product to enter into the device. The spray openings may become blocked.
The free movement of the actuator may be obstructed.
The device must NOT by operated with gases (e.g. air) over a long period, as the cleaning medium is
used for lubrication of the bearings.
The device is NOT suitable for ATEX applications.
The device is intended exclusively for the purpose outlined above. Any other use beyond that described
here or alteration of the device without written approval from the manufacturer is considered
IMPROPER use.
The manufacturer accepts NO liability for damage arising from such use. The operating company is
solely responsible for the risk.