Cubola
®
Solidare
®
EN 20-04-2018
9
Assembly Cubola
®
Solidare
®
Sub-composition support beam front side
1.
Shorten the front profile support beam, mounting profile and front profile to the correct lengths.
2.
Place the drilling template on the top of the profile and drill 4 holes according to the ‘support beam’
pattern. Do the same on the other side of the profile
3.
Drill on both sides of the mounting profile 4 holes of 6.5 mm, as shown hereunder.
Tap M8 thread in the holes and also in the holes on the side.
4.
Place the PVC slide bearing between the fabrics (fasten it later in the mounting profile with self-drilling
screws). Insert PVC inserts into the fabric and wind the fabric top wise around the fabric roller. Make
sure that the groove on the pull side is filed round so that the fabric is not torn by being pulled against
the sharp edge.
5.
Insert bearing bung into the non-operating side of the fabric roller.
6.
Place the motor with friction ring and motor bung into the other side of the roller. Take the direction
of rotation into account.
7.
Place the complete fabric roller into the mounting profile.
8.
Mount the end plate with bearing pin and the end plate with motor bracket to the mounting profile.
Make sure the motor cable is drawn through the cable opening into the end plate. Fasten the PVC
central slide bearing to the mounting profile with self-drilling screw 3,5x9,5.
