Cubola
®
Solidare
®
EN 20-04-2018
26
Installation Cubola
®
Solidare
®
21.
Position the side guide to the front profile and make sure the cord is free in the side guide. NOTE:
Control if the zipper runs in the PVC guide.
22.
Fasten the side guide through the pre-drilled holes with cylinder metal screws M6x14.
Leave the side guides on the floor.
23.
Pull the knot of the cord over the wheel. NOTE: Make sure the cord is not tangled, the cord runs from
the top cover support bottom wise over the wheel.
24.
Drop down the valance system and lift the guides on the front profile.
25.
Fasten the front profile on the end parts of the side guides.
26.
Feed the cord through the front profile as shown below.
27.
Remove the cord tensioner from the front profile for easier positioning of the cord on the wheels. Insert
the cord through the hole in the cord tensioner and pull lightly to tension. Make a knot in the cord at
around 25 cm behind the hole. Cut off the cord after the knot.
Note: Check that the cord runs smoothly over the wheels within the system.
