The basic jig, without a daughterboard, is shown below:
Five pairs of pin sockets are located near the center of the jig. The anode signal is
present on the central pair. The cathode signal is present on two pairs, on the right side
(they are wired in parallel). Two pairs, on the left side, are unconnected.
The daughterboard may be installed in two positions, using three of the five pairs at a
time. The two positions are shown below:
37
Summary of Contents for AVR-EB2A-B
