The AVR-EB2A-B monitors the actual forward bias current through the DUT. If the DUT
has been incorrectly seated, and the forward bias current can not flow properly, the
instrument will detect this problem, display an error message, and turn off the output. If
this occurs, check the seating of the DUT and close both lids again.
The instrument and the DUT will not be damaged if the diode is installed with the
incorrect orientation (i.e., with the anode and cathode reversed). However, incorrect
waveforms will be generated.
The IN, OUT, and CONTROL connectors are on the rear of the jig, below the hinges:
29
Summary of Contents for AVR-EB2A-B
