The four pockets are wired in parallel. Only one DUT may be installed at a time, or the
resulting waveforms will be incorrect.
Once the DUT is installed in the appropriate pocket, close the tan-colored socket lid
and the black main lid. Both must be closed for proper operation.
The tan-colored DUT socket in the AVX-CA-AR1 is a special-order Aries Electronics
(http://www.arieselec.com) part, part number 9890-122-23. The socket may be
replaced by unscrewing the four screws that hold down the main green circuit board,
and then flipping the circuit board upwards. The four screws that hold the socket
against the circuit board can then be removed, allowing the socket to be replaced. The
underside of the socket has coiled spings that contact gold pads on the circuit board.
AVX-CA-SOD123-QTKA
The AVX-CA-SOD123-QTKA test jig will accept SOD123 packages. To install a DUT,
open the main (black) lid like this:
33
Summary of Contents for AVR-EB2A-B
