AVT MAGIC THipPro Lite, Configuration Manual

Page: 71 / 158

▪
Configure the parameters for connecting the
MAGIC THipPro Lite to a network management
system on the SNMP configuration page.
▪
MAGIC THipPro Lite parameters exposed through
SNMP are read-only.
▪
The MAGIC THipPro Lite responds to Get-requests
and sends traps.
▪
SNMP VERSION: Select the SNMP version. MAGIC
THipPro Lite supports SNMPv1 and SNMPv2c.
▪ READ / TRAP COMMUNITY: Enter a string for the
READ community and a string for the TRAP
community. Communities are used to
authenticate the device with the network
management system.
▪ SNMP PORT: Specify the local UDP port for
receiving SNMP requests and sending SNMP
responses. The remote port is derived from
received SNMP requests. (default: 161)
▪
NMS 1-4: Specify up to four network management
stations to receive traps.
▪
LAN: Select the LAN interface of the MAGIC THipPro
Lite which is used to send SNMP traps.
▪
IP ADDR: Specify the IP address of the network
management station.
▪
PORT: Specify the UDP port of the Trap receiver of
the network management station. (default: 162)
▪
SYSTEM DESCRIPTION: Enter a string describing
this particular MAGIC THipPro Lite. This string is
part of the standard MIB.
▪
CONTACT: Enter a string with information about
who is responsible for the MAGIC THipPro Lite.
This string is part of the standard MIB.
▪
SYSTEM LOCATION: Enter a string describing
where the MAGIC THipPro Lite is located. This
string is part of the standard MIB.
SNMP (2)
73