Avolites Pearl Expert Titan, Operator'S Manual

Page: 86 / 149

Page 86 – 8 . Cue Lists
PearlExpertTitan_Man_v2-0.doc 23/09/2009 12:16:00
active using Wheel A or softkey A of the Edit Cue List Cue Times menu.
See the diagrams in section 6.7.1 on page 63 and section 7.7.2 on
page 76 for more information about overlaps and fade times.
1> Press A [Edit Times] at the main Program menu then the Swop
button of the Cue List.
2> To change which cue you are editing, scroll through the list using
Wheel A or press A [Cue Number] then type the cue number you
want to edit and press Enter.
• To set the delay time before the cue starts once the Go button has
been pressed, press B [Delay In] then type a time in seconds and
press Enter.
• To set the fade-in time of the cue, press C [Fade In] then type a
time in seconds and press Enter. Both HTP and LTP channels are
affected by the fade.
• The fade-out time of the cue is set by default to be the same as
the fade in time. You can change the Fade-Out time by pressing E
[Fade Out], then type the time in seconds and press Enter. To set
equal to Fade In time, delete the time and leave the box blank.
• The Delay Out time of the cue would normally be used if the
console links automatically to the next cue, and sets the wait time
before the next cue starts.
• Press G [Next] and use option B [Link to next step] to set an
automatic link between this cue and the next one. If this is set to
Off, you have to press the Go button to move to the next cue.
Otherwise the console will move on automatically after the Delay
Out time.
8.7.2 Individual attribute fade times
You can set individual fade times for each IPCGBES attribute group. You
can also select which fixtures this is applied to. For example you can
make the position change take 2 seconds, but the colour change take
10 seconds.
Additionally you can set individual times for each attribute so you could
make the pan fade over a different time to the tilt.
To set times for an attribute group, first select the Set Times menu and
go to the cue you want to set as described above, then press G [Next]
to go to the second page of options.
1> Press C [Attribute times].
2> All fixtures in the cue will be selected. If you don’t want to change
the times for any fixtures, deselect them now. You can press the
ALL button (below Next Time) to select all fixtures in the cue or
Shift+ALL to deselect all fixtures.
3> Press the softkey for the attribute group you want to change.
4> Press A [Delay] to set the delay time, or press B [Fade] to set the
fade time. Press G [Use global] to remove the attribute group
timing and go back to the normal delay/fade times for the cue.
You can use option C [Individual Attributes] to set times for one
attribute within the group, for example just Pan from within the Position