106
Card Parameters
Output Timing
Normal
VESA
Normal
output timing is designed for some brands of monitor that do not
support the
VESA
standard.
Bezel Gap
Adjustment
(Test Pattern)
(On / Off)
Turn on or off the display of proprietary test pattern on screen for
seamless image alignment in 1×2 wall display and 2×2 wall display.
Note: This item is only available when the item after next is set Wall.
Color Correction
(On / Off)
Turn on or off the decoder (signal in stage) to completely fix any color
anomaly that may appear on color edge.
Note: Make sure to turn this function off when cascading with non-Rainier
3G Plus/Quad and Titan 9000 cards.
Output Display
Mode
Single
Wall
Select between using the Titan 9000-HOB card as direct output of input
source signal to monitor (Single) or to do 1×2 / 2×2 wall display (Wall).
Source
Card 1/2/3
Cascade In
Specify the source of the input signal for wall display (default is signal
from Cascade In port of Control Card – HDMI).
Note: This item is only available when the previous item is set Wall.
The following table shows the Properties setting for each window in the Titan 9000-HOB.
Display
Source
Card 1/2/3
Cascade In
Specify the source of the input signal for direct output to monitor (default
is signal from Cascade In port of Control Card – HDMI).
Note: This item is only available when the item “Output Display Mode” is
set Single.
Crop Size
X
Y
Specify the location of the window appearing on screen by setting the
X
and
Y
coordinates.
Note: Item only available when item “Output Display Mode” is set Wall.
Width
Height
Specify the cropped size of the window appearing on screen by setting the
Width
and
Height
values. You can directly input the value, use the left/
right button (
Width
) and up/down button (
Height
), as well as the
keyboard’s
Ctrl
+ left/right arrow (
Width
) and
Ctrl
+ up/down arrow
(
Height
) keys.
Note:
1. The smallest cropped size should not be smaller than 320
×
180.
2. To prevent distortion on the window's image (for "interlaced" input
signal), make sure the height of the image (excluding label and border) IS
NOT smaller than one-half of the vertical active region of input source
(e.g., if resolution is set at 1080i 50Hz then the image’s height must not be
less than 540 pixels)
3. This item is only available when item “Output Display Mode” is set Wall.
Lock Position
(On / Off)
Lock or unlock the position of the window appearing on screen.
Note: Item only available when item “Output Display Mode” is set Wall.
Bezel Gap
Adjustment (Pixel)
Left/Right
Top/Bottom
(0 to 80)
Note: Refer to Appendix B for instructions on configuring the “Bezel Gap
Adjustment (Pixel)” to set up 1×2 or 2×2 wall display.
Image Adjustment
Brightness
(–128 to 127)
Adjust the brightness quality of the input signal.
Contrast
(0 to 1023)
Adjust the contrast quality of the input signal.
