AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
11
Engine nacelle:
Check the rear of the fuselage for the location of the
two engine nacelles.
Drill a 6 mm hole in the fuselage for the nacelle pins at
the correct location.
Drill a 25 mm hole in the fuselage for the nacelle axis
at the correct location.
Insert the 25 mm diameter fiber tube in the fuselage
Put some wax on the aluminum tube.
Fit the aluminum tube through the fuselage, through the
fiber tube, and through the plywood reinforcements and
fit the two engine nacelles on each side.
Glue with slow epoxy and microballoon the fiber tube
and the two round pin reinforcement plywood pieces.
Let it dry overnight.
Glue the fan cover at the limit of the engine nacelle
Secure the engine nacelle with one x M3x16 mm screw on each side through the aluminum tube
