AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
8
Fit the rudder on the fin.
Cut the rudder according to the engraved panel lines with a Dremel saw (fine saw) or with a diamond disk
Sand the balsa inserted in the fin with a half round Perma Grit tool to have half round in the fin
Sand the control surface half round
Drill 3 X 5 mm holes in the trailing edge fin for the hinge locations.
Insert and glue with epoxy the three hinges in the balsa rib.
Drill the corresponding hole in the rudder.
Insert and glue with epoxy the three hinges in the control surface. Check that the control surface can rotate
freely. All hinges must be perfectly glued.
Cut the hole in the fin skin according to the engraved panel lines for the servo cover
Make a 2 mm slot in the control surface for control horn.
Glue the control horn with epoxy.
Install glue and screw the servo in the servo cover.
Insert in the rudder the servo extension lead
Connect the servo and the control horn with two x M3 links and M3 threaded rod.
