AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
6
Joining the two stabs:
Check the rear fuselage for
the location for the two
stab joining carbon spars.
Drill 2 X 16 mm hole in
the rudder at the correct
location.
Fit the 2 carbon spars
through the rudder. The
Short spar is at the front,
longer at the rear. Both
must be anhedral.
Fit the two stabs on each
side.
Check that the distance
between the top of the
rudder and the tip of the
left and right stabs are
equal.
Glue with slow epoxy and
microballoon the two carbon spars in the rudder.
Put some wax in the stab tube and fit the 2 stabs on the fuselage
Check again that the distance between the top of the rudder and the tip of the left and right stabs are equal.
Hold it in location with tape.
Let it dry overnight.
Make a hole in the fin for the elevator servo lead.
