AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
26
Radio installation:
All batteries must be installed
in the nose to have the correct
CG
There are few possibilities to
fit the radio system (receiver
and valves):
You can install them:
- In the nose cone section.
Access is easy, just remove the
nose cone.
- In the main left access door
(real access door) if you do not
fit the floor and cockpit). You
will access the radio by
opening the door
- At the limit of the rear and
front fuselage. You will have an access only when you disassemble the model or from the main gear
doors.
Connect all the engine tubing to the fuel pump.
Connect the fuel pump to the fuel tank.
Connect all the engine connector to the ECU.
Connect radio and ECU
Connect all the retract tubing to the air valve.
Connect all radio wires
Fit the ECU battery and radio batteries as forward as possible
Secure all the screws with thread lock.
Finishing tips:
Now you have to remove the wax from all the parts to paint.
The best way to do this is to sand all the surfaces with a "scotch brit" scouring pad used to wash up the
crockery
All the parts can also be sanded with #600 grit paper to remove wax.
Do not apply primer on the fuselage, wings and stabs.
They must be directly painted.
Think light: excessive paint build-up will add unnecessary weight to the model. Apply light, thin coats of
paint and sand between coats to avoid excess weight.
