AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
14
Front FUSELAGE
Assembling the nose gear
Cut the front gear door according to the engraved panel lines.
Put the 2 wood ribs forward for a better access from the gear door
Glue on them the 4 mm plywood reinforcement at the limit of the second rib reinforcement
Put the front gear on the wood ribs and plywood
Drill 4 x 2mm hole through the plywood and wood ribs
Screw with 4 x 3mm x 20mm parker screw the front gear on the support
Put backward the wood ribs with gear so that the plywood
reinforcement touches the plywood frame.
Put the front strut in the front gear and secure the gear screws.
Check that the front wheel retract and extend without problem.
Adjust position (forward or backward) if necessary.
Glue the two wood spars in the plywood frame.
Put the steering servo on one side on the pilot floor.
Connect servo to the steering arm.
