Avery Weigh-Tronix FLI 225, Service Manual

Page: 59 / 110

FLSC 05 w/FLI 225 Instrument Service Manual 59
9 Scale
Filter Type
1. Select Filter Type = from the Filter module.
2. Select from the available filtering options. Filter2 is the default setting.
None means no filtering.
Filter1 filtering is slower response to weight in a longer time period with
improved accuracy.
Filter2 filtering is faster response to weight in a short time.
3. Press the Enter softkey to accept and return to the Filter screen.
Constant
If you turn filtering on, you need to set the Constant . Typical values are between 1 and
10 (default = 4). Set the number low for small vibration problems and higher for more
dampening effect.
1. Select Constant from the Filter Module .
2. Press the Up or Down Arrow softkey to choose a number between 0 and 10.
3. Press the Enter softkey.
The constant is stored and the instrument returns to the Filter screen.
Threshold
The purpose of the Threshold is so the instrument will respond quickly to large weight
changes. Threshold is the amount of weight change, in calibration units, beyond which
the filter will be temporarily disabled. For example, if you set this to 10 lbs, a weight
change over 10 pounds occurring during the sample time (½ sec. in our example) will
disable the filter until the weight change during the sample time drops below 10 lbs.
1. Select Threshold from the Filter Module .
2. Scroll in the value in calibration units using the data entry procedure
(Default = 3).
3. Press the Enter softkey to return to the Filter screen.
9.2.4 Motion/AZT
1. Select Motion/AZT from the Scale module to display the following screens.
Figure 9.32 Motion/AZT Screens
2. After defining the settings, press the Esc softkey to exit and return to Scale .