Avaya WLAN Security Switch 2300 Series, Troubleshooting And Debug Manual, Page: 30 / 74

30
NN47250-700 (Version 04.01)
Syntax
WSS# show ap vlan <ap number>
The command output shows the mode of the VLAN as either local or tunnel
„
Check the FDB entry of a specific AP
Syntax
WSS# show ap fdb <ap number>
The command output shows the fdb entries of the AP.
Local switching enabled and the AP cannot boot
After enabling local switching if AP cannot boot up, then check for the following:
„
Check the boot configuration of one AP
Syntax
WSS# show ap boot-configuration <ap number>
The command shows whether AP is configured to boot up from default VLAN or a specific VLAN
„
Check whether the vlan-profile configuration complies with the boot configuration
Syntax
WSS# show vlan-profile
„
Update the vlan-profile
Syntax
WSS# set vlan-profile <profile name> vlan <vlan name> [tag <tag number>]
If AP boots up from default VLAN, then make sure this entry: default none is present in the service profile.
If AP has boot configured on a specific VLAN, then make sure the same VLAN is present in the service-
profile in the format <vlan name> <vlan tag>.
Session is disconnected after roaming
Check whether the overlay mode works. In order to make Inter-WSS roaming work for local-switched
sessions, the tunnel between WSSs is required, therefore the VLAN needs to be configured to support overlay
mode.