Avaya, Inc.
- 70 - PARTNER ACS 1600 DSL module User Guide
Y. Delete a DHCP Assignment Entry
Deletes an assigned IP address from the
Display DHCP
Server Assigned Addresses
command. Type the IP
address to delete, and then press ENTER.
N. Configure
NAT
Displays the
NAT
Configuration Menu
, which contains the
following commands to configure the Network Address
Translation (NAT).
NAT allows you to use one IP address of every workstation in
your company. This hides your internal Intranet addresses.
You must restart the PARTNER ACS 1600 DSL module for
the changes to take effect. For more information on restarting
the PARTNER ACS 1600 DSL module or on upgrading your
software using TFTP, see the “PARTNER ACS 1600 DSL
module basics” chapter.
B. Enable/Disable NAT Debug Messages
Enables and disables NAT debugging messages.
P. Enable/Disable NAT Translation by Port
Enables and disables NAT by port. Type the number of the
Interface, the number of the port to enable, and then press
ENTER. You must enable NAT for all ports that connect to
the Internet.
T. Configure NAT TCP Timeout
Sets the NAT TCP Connection Timeout, a value between 60 -
3,600 seconds (default = 300 seconds). Type the TCP
Timeout value, and then press ENTER.
U. Configure NAT UDP Timeout
Sets the NAT UDP Connection Timeout, a value between 60-
3,600 seconds (default = 120 seconds). Type the UDP
Timeout value, and then press ENTER.
R. Configure NAT Port Range
Sets the range of port numbers to assign to IP connections,
with a low value between 5,000-65,534 (default = 50,000) and
a high range between 50,000-65,535 (default = 65,535).
The size of the NAT port range defines the number of
simultaneous connections permitted. a small port range limits
