Administer Communication Manager
Issue 7 January 2005
221
The information you need to do this should be provided in your planning documentation. Use
the system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region,
defined as 1. The procedure below uses 1 for the network region number as an example but the
procedure applies for any network region number from 1 to 250.
To define IP network region 1
!
CAUTION:
CAUTION:
Defining IP network regions can be quite complex. For detailed information on
the use and administration of IP network regions, see ‘‘Administration for Network
Connectivity for Avaya Communication Manager, 555-233-504.’’
1. At the SAT prompt, type
change ip-network-region 1
.
The S8300 displays the IP Network Region screen.
IP Network Region Screen
2. If necessary, complete the fields as described in ‘‘Administration for Network Connectivity
for Avaya Communication Manager, 555-233-504.’’
Note:
Note:
It is strongly recommended to use the defaults in the screen. However, for the
RTCP Enabled and RSVP Enabled fields, the entry should be n (no).
3. Press F3 (Enter) to submit the screen.
change ip-network-region 1
Page 1 of 19
IP NETWORK REGION
Region: 1
Location:
Home Domain:
Name:
Intra-region IP-IP Direct Audio: yes
AUDIO PARAMETERS
Inter-region IP-IP Direct Audio: yes
Codec Set: 1
IP Audio Hairpinning? y
UDP Port Min: 2048
UDP Port Max: 3028 RTCP Reporting Enabled? n
RTCP MONITOR SERVER PARAMETERS
DiffServ/TOS PARAMETERS
Use Default Server Parameters? y
Call Control PHB Value: 34
Audio PHB Value: 46
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 7
Audio 802.1p Priority: 6
AUDIO RESOURCE RESERVATION PARAMETERS
H.323 IP ENDPOINTS
RSVP Enabled? n
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
Keep-Alive Count: 5