PROCESSOR
Green
. Steady heartbeat indicates processor is
running; off indicates no power.
RJ45 LEDs
The RJ45 Ethernet jack has two green LEDs.
One will glow steady when the link is up and
the other will flash with activity.
DMX INPUT
Amber
. Steady glow indicates port is receiving
active DMX. Off indicates no incoming DMX
signal.
DMX OUTPUT
Green
. Steady glow indicates port is transmit
-
ting DMX. Off indicates no DMX output..
IDENTIFY
Blue.
Blinks when identify is active.
SD CARD OK
Green
. Steady glow indicates microSD card is
present. Off indicates no SD card present or
SD card error/cannot be read.
Model 6824 4-Port Gateway
Manual
11/06/20
The Pathport® 6824 four-port gateway provides the full
functionality of other Pathport gateways in a compact, DIN-
rail mountable form factor.
System integrators can now easily put fully customized
universes of DMX where they are needed. Ideal for use in
NEMA enclosures. Fully compatible with eDIN interfaces.
The Pathport 6824 features terminal strips that can be removed
from the card to facilitate easy wiring installation or replacement.
Make the following connections,
WITH THE POWER TURNED
OFF.
POWER
The 6824 is designed to run on either Power-over-Ethernet (PoE),
or on an auxiliary power supply providing between 24 and 48 volts
DC. The gateway is Class 2 PoE and will draw up to 8 Watts.
If an auxiliary supply is used, observe the correct polarity when
wiring the power IN terminal plug. The earth ground terminal
must be connected to the enclosure’s chassis or electrical ground
terminal to ensure EMC compliance.
DMX512
DMX connections consist of a shield and data pair. Connect DATA+
and DATA- to D1+ and D1-. Observe the same polarity convention
throughout the system. Connect the cable shield or common to the
SHLD COM terminal.
NETWORK
All network wiring should follow standard Ethernet rules and be
installed by a qualified person. As part of the installation, all wiring
should be certified under the TIA/EIA-568 standard.
CONTACT CLOSURE INTERFACE (CCI)
There is a 3-pole terminal connector included for dry contact
closure input. The CCI supports two functions:
DMX Hold
and
RDM
Pause
. See the Pathscape Manual for details on how to enable
these functions
OVERVIEW
CONNECTIONS
STATUS INDICATORS
COM
CC1
NC
NC
D1+
COM
SHLD
D1-
NC
NC
D1+
COM
SHLD
D1-
NC
NC
D1+
COM
SHLD
D1-
NC
NC
D1+
COM
SHLD
D1-
– +
24–48VDC
7W Max
SD CARD OK
PROCESSOR
IDENTIFY
Port D
Port C
Port B
Port A
INPUT
OUTPUT
INPUT
OUTPUT
INPUT
OUTPUT
INPUT
OUTPUT
FACTORY
DEFAULT
DMX512 Inputs/Outputs (4)
Female RJ45
Ethernet connector
microSD
Card Slot
Connect earth ground to
protect DMX ports from
RF interference carried
on cable shield.
24-48 VDC
Power Input
Use eDIN 1001 power
supply or equal.
Factory Default/
Reset Button
Fastening Mechanism designed
for 35 x 7.5mm DIN Rail
Contact Closure/
Expansion Input
