Maintenance strategy
G700 server-controlled maintenance
Maintenance Procedures
55
December 2003
Table 25: Tests not executed on the G700 platform
Test
Notes
NPE_AUDIT
This test is really an audit that sends network update messages to
various ports on a board. Since the Media server does not handle
network connections for the MG, this test is not run.
DS1_DTONE_TS
DS1 CO trunk dial tone seizure test
NEON_TEST
This is run only for those boards that support the neon message lamp.
Therefore, it is not needed for R1.
CLK_HEALTH
Reads the LMM loss-of-clock status bits for the specified tone clock
board
TDM_NPE_XTALK
Checks if the NPE chip is transmitting on more than one timeslot.
Since timeslots are not under the Media server’s control, this test will
not be run.
CONF_TEST
Tests the conference circuit in the NPE. Needs the use of Timeslots;
therefore, this test is not run.
MOD16_LOOP
A 1004Hz reflective analog loop around on an analog port. This test
requires the use of a tone detector and all TDs are under control of the
MG.
GPP_LP
GPP internal loopback tests is sent through both the I and S channels
for a port. A tone detector is needed to detect and report the test pattern.
GPP_NPE
The GPP NPE xtalk test. The Media server does not handle network
connections, so this test is not run.
FT_GPP_LOOP
Factory external loop around test for the GPP board.
FT_LOOP
Factory external loop around test for almost all boards.
ICSU_LEDS
Checks the Integrated Channel Service Unit LEDs, which do not exist
on the DS1 Media Module.
DIAL_TONE_TS
Detects dial tone.
TRK_AUTO_GRD
This test is for the Australian version of the CO board, TN438.
TRK_PPM_TEST
Factory only test for certain CO trunks; requires a pulse generator.
TRK_HYB_TS
Tests the loop around capabilities of a port’s codec and hybrid circuits.
ONS_HYB_TS
Tests the loop around capability on the codec circuit.
BRI_EPF
Electronic power feed test; not valid for TN2185.
L1_INQ
This function actually encompasses several tests.
SSP_TDMLOOP
This is for the messaging angel, but the Media server is unaware of the
TDM bus.
PRI_TSTCALL
Requires the use of either a data channel or a maintenance test board,
neither of which are present.
TDMLP_BRI
The Media server can’t use the TDM bus.
PPP_TDMLOOP
The Media server can’t use the TDM bus.
Summary of Contents for CMC1
Page 1: ...Maintenance Procedures 555 245 103 Issue 1 1 December 2003 ...
Page 14: ...Contents 14 Maintenance Procedures December 2003 ...
Page 416: ...Additional maintenance procedures IP Telephones 416 Maintenance Procedures December 2003 ...
Page 426: ...Index X 426 Maintenance Procedures December 2003 ...