Avaya CMC1, Maintenance Procedures

Page: 411 / 426

Additional maintenance procedures
Setting G700 synchronization
Maintenance Procedures 411
December 2003
The results from the above command are shown in Table 100 :
If a secondary is similarly provisioned:
To activate the secondary, the following is similarly done:
To activate local the following is done:
Table 100: TEST RESULTS
Port
Maintenance
Name
Alt. Name
Test No.
Result
Error Code
001V4 MG-DS1 144 PASS
Command successfully completed
Table 101: mgp-001-1(configure)# set sync interface secondary v3
mgp-001-1(configure)# show sync timing
SOURCE MM STATUS FAILURE
Primary V4 Active None
Secondary V3 Standby None
Local V0 Standby None
Table 102: mgp-001-1(configure)# set sync source secondary
mgp-001-1(configure)# show sync timing
Source MM Status Failure
Primary V4 Locked Out None
Secondary V3 Active None
Local V0 Standby None
Note: The system uses one clock at a time only: therefore only the secondary is active and the
primary is locked out.
Table 103: mgp-001-1(configure)# set sync source local
mgp-001-1(configure)# show sync timing
Source MM Status Failure
Primary V4 Locked Out None
Secondary V3 Locked Out None
Local V0 Active None