44
2.2
Introduction
•
The program determines most of the control panel features. Programming is performed in
order to enable maximum compatibility of the control panel with the specific site.
•
The control panel is supplied with the basic ‘Factory Default Program,’ which is in effect at
system power up. (See also: Factory defaults programming.). Factory default setting:
Enter 6 9 in address 200, to revert to factory default programming
•
Before starting programming, mark the desired values on the programming sheet.
2.3
Programming Sheet Explanation
Table 1
:
Enter the zone feature by zone number, as described in addresses 100 to 191.
Table 2
:
Addresses 010 to 013 used to enter the telephone numbers that dialed upon alarm or at
other events (when communicator to central station has been programmed).
Telephone numbers 2 & 3 are for communicator (if selected), or non-communicator, according to
programming of addresses 021 & 022. Telephone numbers 1 & 4 are only for regular telephone
dialer with sound alarm.
Table 3
: Addresses 060 to 069 indicate the times out. Enter the time in two digits. (e.g. for two
seconds, enter 0 and then 2).
Address 074 and 075 manage five different features that specify the alarm outputs upon Panic and
Tamper alarm.
Note:
entering a ‘0’ value at address 074 or 075 will delete all four-alarm outputs during Panic or
Tamper alarm at that address zone.
Table 4
:
Addresses 070 to 072 indicate special features of the system. Enter the required features
by their number in each address. Each address contains 8 different parameters.
Table 5
: Addresses 080 to 092 indicate telephone specifications according to local telephone
company requirements. Address 091 and 092 sets the up and download modem.
Table 6
: Address 099 provides setting of user codes 1 to 17 within the programming mode.
Table 7
:
Address 200 reverts system to factory default by entering 69. Entering 77 in address 200
sets panel to local up and download.
Table 8
: Addresses 021 to 036 sets the communicator parameters according to your central
station's specifications. Contact the central station for full details.
Table 9
: Addresses 040 to 054 provides selection of the required events to be reported. For
example, to select zones 1,2 and 6 for Zone Restore report program 1,2 and 6 in address 045. Do
not program if Contact ID format selected.
