AUX ASW-07B4/HSAR, Service Manual

Page: 96 / 159

z
If it is an overhanging installation, the structure of the mounting wall should be made of solid,
cement or materials with equivalent strength, and of sufficient support capacity. Otherwise,
measures such as reinforcement, support or vibration damping should be adopted.
Installation of the Indoor Unit
z
First make changes to wall and make sure that is hard and secure. Using four “+” type screws
to fasten the installation board onto the wall. Keep it level in horizontal direction and
perpendicular in vertical direction. Otherwise it might cause water drips when air-conditioner
is running in cooling operation.
z
Drill 70mm diameter pipe hole at the left lower or right lower side of the installation board.
The hole shall slant outward slightly.
z
Hang the indoor unit to the
board and make sure the
machine is in the middle of the
board.
z
Push the machine towards
the left lower and right lower
side of the installation board
until the hangers enter tightly
into the grooves (it produces
“click” sound)
Check the water discharge
1. Take off the frame from the unit
cover.
Take off the front frame for
maintenance according to the