Chapter 8: Installation and Wiring
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Do-more T1H Series PLC User Manual, 1st Edition, Rev. C
8-10
Connecting the Components on the DIN Rail
SLIDE ASSEMBLY INTO POSITION ON THE DIN RAIL
Slide the module assembly on the DIN rail until the clip arm attaches securely to the
adjacent module.
NOTE:
One power supply is required in the leftmost component position followed by the CPU. Additional
power supplies should be added between I/O modules as necessary to meet power budget requirements.
Each power supply powers the modules to its right, but is interrupted by the next power supply.
Removing I/O Modules from the Base
To remove a module from the base, grip the center of the base arm and rotate outward
releasing the module. Lift the module from the base.
To remove a module assembly from the DIN rail, lift the clip arm up and slide the module
assembly away from the adjacent module. Pull the locking tab down (out) and lift the
assembly off the DIN rail.
RUN
I/O
STAT
USB
TX
RX
TERM
RUN
STOP
T1H-DM1E
USB
PGM
PORT
RUN
I/O
STAT
USB
TX
RX
TERM
RUN
STOP
T1H-DM1E
USB
PGM
PORT
WARNING: The T1H Series PLC does not support any Hot-Swap features.
