Owner Installation Instructions
Easy Slider - Sliding Gate Opener
5
The opener is showerproof - it should not be immersed in water or sprayed directly by a hose or other water
carrying device.
The gate(s) must be
well balanced
. and in good working order. Faulty gates must be repaired by a
qualified technician prior to opener installation.
Remove or disengage
all gate locks and mechanisms prior to installation of the opener.
Connect the gate opener to a properly
earthed
general purpose 240V mains power outlet
installed by a qualified electrical contractor.
Disconnect the power cord
from mains power before making any repairs or removing
covers. Only
experienced
service personnel should remove covers from the gate opener.
Keep hands and loose clothing
clear
of the gate and opener at all times.
When using auto close mode a
photo electric beam
must be fitted correctly and
tested for operation at regular intervals.
extreme caution
is recommended when
using auto close mode.
all safety rules
above must be followed.
In order for the gate opener to
sense
an object obstructing the gateway, some
force
must be exerted on the object. As a result the object, gate and/or
person may suffer
damage
or
injury
.
Make sure that the gate is fully open before driving into or out of the
driveway. And make sure the gate is fully closed before leaving the
driveway.
The gate opener is not intended for use by young children or
infirm persons without adequate supervision. Children should
be supervised to ensure that they do not play with the remote
transmitters or the opener.
Frequently examine the installation, in particular guides
and mountings for signs of wear, damage or imbalance.
DO NOT
use if repair or adjustment is needed since
a fault in the installation or an incorrectly balanced
gate may cause injury.
Important safety instructions
Please read this instruction manual fully before attempting
to install or use the opener. Failure to comply with the
installation instructions may result in serious injury and/or
property damage.
