AUTHOR Alarm IGLA, Operating Manual, Page: 7 / 52

7
In order to log into the system it is enough to have
the key fob or smartphone paired to the system. You
can register 2 key fobs and 2 smartphones in the IGLA
system memory. For authorization in the system you
need to have with you at least one registered device.
Get into the car and switch ON the ignition. When the
key fob/smartphone is detected, the system will give
out two verification signals (see the annex), after that
you can start driving.
If the key fob/smartphone is not detected, there will be
no verification signals and if one attempts to start the
engine or drive, the engine will be locked.
Authorization with the PIN-code
The authorization method depends on the chosen way
of engine locking:
• If the system inhibits the engine start, the PIN-code
should be entered before the start of the engine.
• If the system does not inhibit the engine start, the
PIN-code can be entered both before the start of the
engine or after.
The initial PIN-code is set by the specialists of the
service centre. Before running the system for the
first time change the PIN-code and memorize a new
one (see page 18).
Get into your car, switch ON the ignition, start the
engine if needed and enter the PIN-code using the
standard vehicle buttons*.
* Some buttons start functioning in 2-5 seconds after switching on
the ignition or starting the engine (see the annex). Moreover, some
buttons can be pressed not more than one time per second.
!