AUTHOR Alarm IGLA, Operating Manual, Page: 19 / 52

19
Also it is recommended to change the PIN-code if you
suspect someone has watched you entering the PIN-
code.
1.
Switch ON the ignition without starting the engine.
2. Enter the current PIN-code to authorize. There will
be 2 indication signals.
3. Press the accelerator pedal* as far as it can go and
keep it pressed.
4. Enter the current PIN-code once again. The device
will pass to the PIN-code change mode and the
indication signals will start flashing every 3 seconds.
Release the accelerator pedal*.
If the current PIN-code includes «Slight touch on
accelerator pedal», after the authorization (item 2)
it is necessary to enter the PIN-code once again and
then press the accelerator pedal as far as it can go
and keep it pressed until indication appear. Then
perform item 5.
5. Enter the new PIN-code using the buttons
available for programming (see the annex). Every
click will be followed by the indication signal .
The number of clicks shall be in the range from 3
to 20 clicks. The interval between clicks shall not
be more than 2 seconds. There is no difference
between long and short press of the button .
Different combinations of buttons and their order
can be used, e.g. if you press CRUISE ON/OFF two
times and press CRUISE SET- once, the system will
save all the clicks in this order. When the PIN-code is
entered there will be 3 indication signals.
* For some car model other controls are used instead of an accelerator pedal
(see the annex).
!