AUTHOR Alarm IGLA, Operating Manual

Page: 17 / 52

17
2. Enter a PIN-code using the buttons available for
programming (see the annex). Every click must be
followed by the indication signal. The number of
clicks shall be in the range from 3 to 20 clicks. The
interval between clicks shall not be more than 2
seconds. There is no difference between long and
short press of the button.
Different combinations of buttons and their order
can be used, e.g. if you press CRUISE ON/OFF two
times and press CRUISE SET- once, the system will
save all the clicks in this order. When the PIN-code
is entered there will be 3 indication signals.
3. Enter the current PIN-code once again. If PIN-codes
match there will be 2 indication signals and the
PIN-
code will be successfully saved .
If there are 4 indication signals, it means the PIN-
code do not match and the PIN-code has not been
saved
. Switch OFF the ignition for 3 sec. and repeat
the items 1-3.
4. Switch OFF the ignition.
5. Disconnect the RED and the GREY wires from the
permanent power supply «+12V» in order to reload
the device.
6. Connect only the RED wire to the supply circuit (do
not connect the GREY wire!).
If the initial PIN-code is set by the specialists of the
service centre during the installation, it is strongly
recommended to change it and memorize a new
one (see below).
!