AUTHOR Alarm IGLA, Operating Manual

Page: 13 / 52

13
1. Switch ON the ignition without starting the engine.
2. Press the brake pedal and while keeping it pressed
press the accelerator* pedal a certain number of
times as far as it can go where the number is equal
to the first figure in the Emergency code. Release
the brake pedal. The first figure of the code will be
entered.
3. Input all the rest figures of the Emergency code in
the same way (see item 2).
If the PIN-code is correct, the device will pass into the
PIN-code change mode and will give out indication
signal every 3 seconds. Press the service button 5
times.** The interval shall not be more than 2 seconds.
The activation of the service mode will be confirmed by
5 indication signals.***
In order to deactivate the transport mode
enter the
valid PIN-code. The 2 indication signals will show that
the service mode is deactivated.
Protection from car key programming
Protection from car key programming (key cloning)
is available for some car models (find more info at
our web-side author-alarm.com, in section System
compatibility). This option protects the car from
programming a new chip for car key that could be used
by criminals to start the engine.
If you need to program a new car key in the service
centre the Service mode shall be switched ON. You
can do it by pressing Service button 5 times after the
authorization in the system was successful.
* For some car models other controls are used instead of an accelerator pedal.
** See the annex. *** The signals depend on a car model.