CHAPTER 9: MAINTENANCE TAB - CONFIGURATION
MDU Solutions
®
– DVIS/DVISm - Digital Video Insertion System & Mini Digital Video Insertion System - Installation & Operation Manual
9-5
All settings from ‘Encoder Settings’ page get exported and later loaded in the other DVIS.
3. MUX and RF Settings
All settings from ‘MUX and RF Output’ pages get exported and later loaded in the other DVIS.
4.
IP Output Settings
All settings from ‘IP Output’ page get exported and later loaded in the other DVIS.
5.
Maintenance Settings
All settings from ‘Maintenance’ page other than Network settings get exported and later loaded in the other DVIS.
6. Network Settings
All settings from ‘Network Settings’ section on the Maintenance page get exported and later loaded in the other DVIS.
7. Demod and MUX Settings
All settings from the ‘Demod and MUX Settings’ page get exported and later loaded in other DVIS.
NOTE: Because the ‘
Demod and MUX Settings’
page uses data from an incoming QAM in a
specific QAM RF distribution network, exporting and loading these parameters only makes sense
if the ‘receiving’ DVIS operates in the exact same QAM RF network. Otherwise in a different QAM
RF network this export settings file won’t work because the QAM channels, programs, frequencies,
etc. could be different, therefore incorrect values will be loaded.
NOTE: In order to generate settings in the ‘Demod & MUX Settings’ page it is required to connect
the DVIS to the QAM RF network to collect data as required for the Demod & MUX page. Parameters
in all other GUI pages are generated directly in DVIS, but parameters in the Demod & MUX Settings
page are a combination of real-life received/analyzed data and modification performed by the
DVIS. It is important to note that the Demod & MUX page data always and only can be created in
the system in question and cannot be generated in a lab/office located elsewhere.
