ATTO Technology ATTO FibreBridge 2350C, Installation And Operation Manual

Page: 36 / 109

25
ATTO Technology Inc. FibreBridge Installation and Operation Manual
1.9 ATTO FibreBridge 2400C
The ATTO FibreBridge 2400C is a 4-Gigabit Fibre Channel to SCSI bridge which can be embedded in
a variety of enclosures to integrate industry-leading performance and SAN capabilities into future
generation storage solutions.
The FibreBridge 2400C includes two independent 4-
Gigabit Fibre Channel ports and independent dual-
stacked SCSI ports available in an industry-standard
4U cPCI form factor. The FibreBridge 2400 auto
negotiates to 1- 2- and 4-Gigabit Fibre Channel.
Board dimensions
Width: 6.1939 inches
Length: 6.299 inches
Height of tallest component: .545 inches
Cooling and airflow
Operating Temperature: 0-40° C
Humidity: 10-90% non-condensing
Power
The drive power connector (18 watts) allows the
FibreBridge 2400C to draw power from a standard
12/5V drive.
Fibre Channel port
The dual independent 4-Gigabit Fibre Channel ports
can connect the FibreBridge to either a Fabric or
Arbitrated Loop.
• Full support for full duplex FC data transfers, FC-
AL, PLDA and public loop login.
• Small Formfactor Pluggable (SFP)
interface
• Auto negotiates with 1-, 2- and 4-Gb/sec.
devices
SCSI ports
The two SCSI ports connect storage devices into
the Fibre Channel Storage Area Network (SAN).
Each port is totally independent from the other.
The ports are Ultra 320 SCSI busses with
VHDCI connectors, downward compatible with
all forms of single-ended SCSI and all previous
SCSI protocols.
Ethernet port
The 10/100 Base T Ethernet port is accessible from the
RJ45 connector. Local diagnostics are supported
through an integrated web server, ATTO ExpressNAV,
the preferred management tool. Includes support for
DHCP, Telnet, FTP, ICMP and SNMP.
Serial interface
The 10-pin serial connector provides remote
monitoring and management through a command line
interface.
LED indicators
Power:
indicates if power is available from the
supply.
FC 1 and FC 2 Activity:
LEDs blink to show
activity on the Fibre Channel ports (numbered 1 and
2). During very high activity, the LEDs appear to be
steadily lit.
SCSI 1 Activity, SCSI 2 Activity:
each SCSI bus has
its own LED to show activity on that bus (numbered 1
and 2).
Ready:
lights after power has been applied indicating
the FibreBridge is ready to operate.
Ready/Fault LED
Ethernet port
Fibre Channel ports
SCSI ports
SCSI activity LEDs
FC activity & link LEDs
cPCI connector
10-pin serial header
mounting hole
power LED