Atosa ATCO-513B-1, Operating Instructions Manual

Page: 29 / 33

- 27 -
1.Loosen the jam nut on both turnbuckles.
2.Make adjustments simultaneously to both turnbuckles.
3.Loosening or tightening the assembly will not allow the doors to work
properly. Ideally, you should loosen one turnbuckle and tighten the other.
Some
experimentation will indicate which direction you will want to make your
adjustments.
4.Once the doors are operating properly, retighten the jam nuts so the unit stay
in adjustment. Test the door to make certain it is in adjustment.
5.Replace cover.
DOOR SWITCH ADJUSTMENT
You may also wish to adjust the door switch. The door switch is located behind the
combustion compartment cover, on the right side. The door switch is activated by a cam,
which is mounted to the door's hinge pin with a setscrew.
1. Open the doors fully.
2.
Remove the lower cover by loosening the four screws located inside the door opening.
3.
Position the doors so they are nearly closed but not latched.
4.
To adjust the cam loosen the setscrew and rotate the cam until you hear the switch click.
5.
Tighten the setscrew in the cam. Test the door to make certain the switch will make contact
with the doors closed.
6.
Torque setscrew to 60 in-lbs.
7.
Replace the combustion cover.
WARNING : The door turnbuckles and door switch are located in a heated in a heated
zone. Care should be taken to avoid burns.