ATN PIAF 10E 2018, Safety And Maintenance Manual

Page: 38 / 81

SAFETY AND MAINTENANCE MANUAL
1NO0055UK-00
PIAF 10 E
38
WARNING
BEFORE STARTING AGAIN, IT IS
NECESSARY
TO SOLVE THE
PROBLEM THAT CAUSED THE
EMERGENCY STOP.
4.4.2 HYDRAULIC TANK
Check the hydraulic oil level through the transparent tank.
Check the levels only when the machine is fully lowered.
4.4.3 TILT SENSOR
- Place the machine on a slope with a grade greater than 2°.
- The alarm in the lower electrical box sounds.
- The red tilt indicator on the upper control box must be lit.
- The machine should switch to slow speed.
- This indicates a good working order of the tilt detection.
4.4.4 CHAIN SLACK SENSOR
- NOTE -
The following controls must be done on each sensor at each
chain stage.
- Wedge a block between the actuator and the sensor to
actuate the sensor.
- Check the emergency stop switches are pulled out.
- The red chain slack indicator on the upper control box must be
lit.
- The buzzer sounds.
- The mast lowering movement is disabled.
- All the other movements function normally.
4.4.5 OVERLOAD SENSOR
- Place a load heavier than 200 kg in the platform (230 Kg max).
- Check the emergency stop switches are pulled out.
- The red indicator on the upper control box must be lit.
- The buzzer sounds.
- All the movements are stopped.
4.4.6 EMERGENCY STOP
- In case of a serious incident, depress the
emergency stop switch.
- Solve the issue.
- Pull on the emergency stop switch to restore the
electrical power to the machine (by a ¼ turn).