ATN PIAF 10E 2018, Safety And Maintenance Manual

Page: 21 / 81

SAFETY AND MAINTENANCE MANUAL
1NO0055UK-00
PIAF 10 E
21
DANGER
THE BATTERY TRAY IS AN INTEGRAL
PART
OF THE
MACHINE’S
COUNTERWEIGHT. REPLACING IT BY
A LIGHTER OR HEAVIER BATTERY
WILL AFFECT THE STABILITY OF THE
MACHINE.
DANGER
PROCEED WITH CAUTION WHEN
DRIVING THE MACHINE NEAR HOLES,
PAVEMENTS.
DANGER
CONSIDER ALL SITUATIONS THAT
CAN AFFECT THE STABILITY OF THE
MACHINE.
DEATH OR SERIOUS
INJURIES COULD RESULT FROM THE
MACHINE TIPPING OVER.
- BEFORE OPERATION, CHECK THE
ENTIRE WORKSITE AS WELL AS
THE
CONDITION OF THE
GROUNDS WHERE THE MACHINE
WILL BE USED.
- MAKE SURE THE LOAD IN THE
PLATFORM
IS EVENLY
DISTRIBUTED AND SECURED.
- NEVER EXCEED THE RATED
CAPACITY INDICATED ON THE
MANUFACTURER’S PLATE.
- USE THE WORK PLATFORM ONLY
ON
FIRM AND HORIZONTAL
GROUNDS.
- DO NOT DRIVE THE PLATFORM
NEAR HOLES.
- DO NOT MOVE THE PLATFORM
ABOVE HOLES OR ANY OTHER
OBSTACLES ON THE GROUND.
- NEVER LOWER THE PLATFORM
ONTO OBSTACLES.
- DO NOT USE THE MACHINE AS A
CRANE.
- NEVER ADD ANYTHING ON THE
MACHINE THAT COULD INCREASE
WIND LOAD SUCH AS DISPLAY
PANELS.
You must wear appropriate clothing and the necessary protection equipment (helmet, harness,
gloves…) required by the work regulations.
Do not allow anybody to tamper with or to operate the machine from the ground with personnel in
the work platform except in emergency situations where it is impossible to lower the platform and
exit the basket.
2.3. MACHINE STABILITY
Never drive the machine on slopes that exceed
the maximum permissible incline (2° max. in work
position or 25% fully lowered). In work position, a
tilt alarm sounds and an indicator lights up on the
upper electrical box as soon as you reach a
dangerous situation. Never disable them under
any circumstances.
Do not use a ladder in the basket or climb on the
guardrail to provide additional reach. This will
affect the stability of the machine and place you in
a dangerous situation.
To prevent any accident when driving
on a slope or on irregular grounds ,
the work platform must be fully lowered , in slow speed , and the basket
always on the lower side of the slope .
(see drawing opposite)