AT-UHD-SW-510W
60
Appendix
16.
Click the
Reset
button, next to
Factory Reset
.
The factory-reset procedure will take approximately 90 seconds.
Reset button
WARNING:
Performing a factory reset will erase all settings and configuration information.
Make sure that all current settings and values are recorded before proceeding. Performing a factory
reset will also set the AT-UHD-SW-510W to DHCP mode. If a static IP is being used, make sure to
record these IP settings.
17. During the update process, the following message will appear in the upper-right corner of the screen:
18. After a while, the following message will appear at the top of the screen:
19. Click the message to return to the
Login
screen. Enter the login credentials, using the default username and
password:
User
admin
Password
Atlona
20. Power-cycle the AT-UHD-SW-510W by disconnecting and reconnecting the power supply.
21.
Login to the web GUI using the default username and password.
The AT-UHD-SW-510W has been reset to factory-default settings and will use DHCP (if a DHCP server is
available) to assign itself an IP address, once connected to a network.
If a static IP was used prior to the firmware update procedure, refer to Step 3a.
(continued on next page)
