ATI Technologies SmartTachSmartTach, User Manual

Page: 24 / 110

CONFIGURATION
Page 3-4 SmartTach Operating Manual
The display format in this mode is XX>YYYYY where XX=Parameter Item
Number and YYYYY=Current Value.
Using the Pushbutton Switches
The four built-in Pushbutton switches are used to access the various
configuration parameters and make any necessary changes. The
function of each switch depends on the current operating mode (as
indicated by the LED lights on the front panel). All four Pushbutton
switches are momentary-type with a snap-action. Depending on the
switch and mode, holding a switch down will result in a repeating action
of that switch similar to a computer keyboard. After an initial delay, the
action caused by the particular switch will begin to repeat at a fixed rate.
Pushbutton Switch Functions
The function of each Pushbutton switch depends on the current operating
mode. The information below describes the function of each Pushbutton
in each operating mode.
S m a r tT a c h
PULSE CONFIG
ENTER MODE
2 3 5 0 r p m
Measurement
Mode
Display: Measured data
PULSE: Flashing (if pulses are being received)
CONFIG: Off : Display Min Input Value
: Display Max Input Value
ENTER: Toggle Display On/Off
MODE: Enter
Configuration mode
Parameter Group
Select
S m a r tT a c h
PULSE CONFIG
ENTER MODE
> S e t u p ! <
Display: Parameter Group name between
> <
symbols.
PULSE: Flashing (if pulses are being received)
CONFIG: On
: Scroll Group Names Down
: Scroll Group Names Up
ENTER: Select Displayed Parameter Group
MODE: Exit
Configuration mode
S m a r tT a c h
PULSE CONFIG
ENTER MODE
0 0 > E n g S p
Parameter Select
Display: Parameter Id and Current Value.
A steady
>
symbol indicates select mode.
PULSE: Flashing (if pulses are being received)
CONFIG: On
: Scroll Parameter Numbers Down
: Scroll Parameter Numbers Up
ENTER: Select Displayed Parameter for Editing
MODE: Exit to Parameter Group Select