ATI Technologies SmartTachSmartTach, User Manual

Page: 23 / 110

CONFIGURATION
SmartTach Operating Manual Page 3-3
Configure
This operating mode displays the configuration parameters or parameter
groups (one at a time) on the built-in display. This mode is used to select
the desired configuration parameter to be displayed and/or changed.
All measurement operations are suspended when in this mode.
Default Configuration Values
The SmartTach has internal default settings for all of the configuration
parameter values. These are the values which are programmed into the
SmartTach when it is first shipped. Many of these values can be left at
their default settings for most applications. Appendix A includes a list of all
SmartTach parameters and default values.
NOTE: All SmartTach parameters can be reset to their default
settings by selecting Item
F2
from the
Memory
Group.
Configuration Controls
The SmartTach has four built-in Pushbutton switches which serve several
purposes, one of which is to allow configuration of the unit. The other
purposes are described in the Operation section of the manual. There are
also two red LED lights (marked PULSE and CONFIG) on the front panel of
the unit which indicate the current operating mode. The CONFIG LED will
be illuminated when the SmartTach is in configure mode.
When the unit is in normal operation (Measure Mode), the display
indicates the current measured value. When the unit is placed in the
Configuration Mode by pressing the MODE button, the display format
changes to Parameter Group Select.
S m a r tT a c h
PULSE CONFIG
ENTER MODE
> S e t u p ! <
Figure 3 - 1: Parameter Group Display
The display format in this mode is >XXXXXX< where XXXXXX=Parameter
Group Name. Pressing the ENTER button again will display the Parameter
List for the selected group.
S m a r tT a c h
PULSE CONFIG
ENTER MODE
0 0 > E n g S p
Figure 3 - 2: Parameter List Display