Athena 1090 EVO, Translation Of Original Instructions, Page: 115 / 182

115
fully charged; a simple way to check is
turning on the internal combustion
engine, which must turn on easily.
•
Make sure that the gate leading to the
platform closes and locks itself
automatically once released.
•
Do not run the engine in closed areas
like garages or the like. The engine
exhaust gas contains carbon monoxide,
a poisonous gas that can quickly
saturate a closed space and cause
difficulties or even death.
lifting the platform to a height that involves an
angle of the scissor frames of 23° with respect
to the horizontal (maximum height of transit
area 4.5mt) and make sure that it is possible to
travel with the machine only at reduced speed
(light indicator 2 flashing ). Also make sure that
at greater heights the light indicator (2) turns
off and that it is not allowed to move.
•
Check that with the platform lifted higher than
the transport height but lower than the
maximum travel height (light 2 on) and moving
on non-level terrain, the machine stops
automatically when the inclination of the frame
with respect to the horizontal exceeds 1°.
Release the travel control; when this control is
operated again or when the lifting control is
operated, the system must bring the frame
back to the horizontal position automatically.
After the levelling, the machine will perform
the selected movement.
•
Lift the platform to a height greater than the
transport height, check that the manual
levelling functions are not allowed.
•
Operate the emergency button on the remote
control (or radio control); make sure that the
engine turns off (both the internal combustion
engine and the electrical engine) and that no
functions are allowed. Release the mushroom-
shaped button after this test.
•
Operate the ground movement emergency
button; make sure that the engine turns off
(both the internal combustion engine and the
electrical engine) and that no functions are
allowed. Release the mushroom-shaped button
after this test.
•
Operate the warning buzzer and make sure it
works.
•
Check the operation of the buzzer when the
travel or work platform descent functions are
used.
•
Make sure, with the machine travelling and the
platform in the transport position (with travel
selector on DM) that, when the Joysticks are
released, the machine stops immediately.
•
Make sure that the manual emergency descent
device works properly.