Athena 1090 EVO, Translation Of Original Instructions, Page: 110 / 182

110
5.2 Transporting the machine in an emergency
To move or transport the platform using external equipment, refer to paragraph
2.5
5.3 Emergency movements from hydraulic block
Warning: this operation must be performed only by qualified technicians trained
by Almac Srl
If the control unit is not working but it is possible to turn on the internal
combustion engine or the electrical engine, then it will be possible to perform
then movements of the machine directly from the hydraulic block.
To perform the movements, it is necessary to release (by turning it counter-
clockwise) safety valve 3 and tighten (by turning it clockwise) valves 1 and 2
(equipped with a lead seal).
WARNING: If valve 3 is not reset in the fully activated position by pressing and
turning it clockwise (you will hear a click) and valves 1-2 are fully unscrewed
(replace the lead seal), the safety of the machine is compromised and the
platform may overturn.
WARNING: Since the operations are performed near the tracks, there is a risk
of crushing