Athena 1090 EVO, Translation Of Original Instructions, Page: 106 / 182

106
The table below shows the list of alarm/error codes.
CODE DESCRIPTION
FUEL Low fuel level (only Kubota engine)
(Warning: This alarm is not stored)
90 Starter battery voltage lower than 9V
91 Starter battery voltage higher than 16V
92 EPROM memory internal error
93 CAN network communication error
40 Frame angle sensor redundancy error
30 Scissor angle sensor redundancy error
70 Pressure transducer redundancy error
41 No signal from the frame angle sensor 1
31 No signal from the scissor angle sensor 1
71 No signal from the pressure transducer 1
42 No signal from the frame angle sensor 2
32 No signal from the scissor angle sensor 2
72 No signal from the pressure transducer 2
10 No signal from the console
50 Right connecting rod angle sensor redundancy error
80 Left connecting rod angle sensor redundancy error
51 No signal from the right connecting rod angle sensor 1
81 No signal from the right connecting rod angle sensor 2
52 No signal from the left connecting rod angle sensor 1
82 No signal from the left connecting rod angle sensor 2
110 Low engine oil pressure (only Kubota engine)
111 Water temperature too high (only Kubota engine)
115 Platform upward movement detected without selecting the
command
131 Alarm relay KM11 bonded
132 Alarm relay KM12 bonded
133 Alarm relay KM13 bonded
134 Alarm, the platform lowered limit switch signal is not consistent
with the value of the scissor angle sensor